Design and Construction of Bolt Pressure Plate Anchorage Plug Rubber Dam

The Wang Jing 1 profile rubber dam is a new type of low head building that has emerged with the development of the high-strand synthetic fiber and rubber industry.It is made of high-strength synthetic fiber and coated with rubber as a protective layer inside and outside.After the water is injected into the bag or inflated and inflated,the upstream water level is controlled to play the role of irrigation power generation,shipping,flood control,moisture,etc.Before the promotion and application of rubber dam technology,no matter in the small country,it is greatly despised in China.
The rubber dam that has been built in Xuzhou has two types of dam-type anchors,which are anchored by wedges and clamped by bolts.In the former,the wedge and the anchor groove are easily destroyed when the dam bag is replaced,which brings difficulties to the construction in the future.The latter has a high safety performance and is quick to change the dam bag.Therefore,the diameter spacing of the bolts has been determined in recent years.Length and section of the platen.For the convenience of installation,each pressure plate should be too long and too heavy,especially,the design of the two-slab side wall pressure 2 bolt platen anchoring plate 4 bolts corresponding to the number of bolts 4 bolts;plate anchored juice 1.

It is necessary to pass the juice,too little will cause one,the snails are pulled off,the hydraulic vibration of the cows is high,and the hydraulic vibration has a high working range,and the pulsation range is extremely small.The siphon has a sudden rise and fall of 1 liter.Even though it has passed the saddle head lift twice,this vibration phenomenon has not been found.2.4 Analysis of the vibration of the water pump Jiangdu stood at the entrance and exit water level difference of 6.51 or more,and there was strong vibration,which could not be stabilized.